Wire Size, Ampacity, and Conversion Reference

Published conductor data for electricians, engineers, and students — AWG conversion, NEC ampacity, voltage drop, conduit fill, and identification — with the standard and conditions stated on each page.

Reference tools

Use the charts and calculators below for common conductor questions: cross-section, ampacity, voltage drop, conduit fill, and identification. Figures are taken from published standards and are labeled with the conditions that apply.

How these figures are presented

Ampacity values on this site are the published copper and aluminum values from NEC Table 310.16 (formerly Table 310.15(B)(16)) for not more than three current-carrying conductors in a raceway, cable, or earth, with a 30°C (86°F) ambient temperature. Those table values are not automatically the allowed overcurrent-device size. The small-conductor rule in NEC 240.4(D) generally limits 14 AWG copper to 15 A, 12 AWG copper to 20 A, and 10 AWG copper to 30 A, even when a higher-temperature column shows a higher ampacity.

Voltage-drop and conduit-fill tools state their formulas and the tables they use. If an installation is in free air, has more than three current-carrying conductors, a different ambient temperature, or terminations rated only 60°C, the allowed current will differ from the base table.

Disclaimer: This site is a general reference only. It is not a substitute for the adopted electrical code, manufacturer instructions, or the judgment of a licensed electrician. Ampacity, overcurrent protection, voltage drop, and conduit fill depend on conductor type, temperature rating, ambient temperature, the number of current-carrying conductors, termination ratings, installation method, and local amendments. Always verify figures in the edition of the code that applies to your work.